hello everyone,
I have a problem with my Dolev. It occurs every now and then alternately. It film feed but will not plot.
1. Course Calib Error
2. No LDT intens change.
what could be the problem?
Thank you in advance for your advices.
Dolev800V/GJ OLP/PSM 7
Hi Osmond,
I'm facing with low speed of spinner for my Dolev 800V. Before, it ran at 21K rpm, now I only can let's it expose at 12K rmp. I don't know what's happening...
PM me and I will give you some manual for dolev to find correct P.N or Cd Creo planet which is most helpful.
Good luck
Leo
PM sent. I've experienced that low speed too before... they said spinner is starting to fail.
Hello Osmond,
What is the latest with your Dole800? Are you any further with the problem?
All is ok since my last post (dec 10). But today another error occurs and we cannot plot anything.
1. Work point set error
2. extra laser current
is the still related to my previous errors? Please help...again... Thank you very much.
Hello PACH,
Thank you very much for you fast reply. I wish we have a tech guy like you around in our country. I believe we have only one or two certified engineer from kodak-creo around here that I cannot immediately get their support due to, I did not get my dolev from their office. If you are here, you can make a lot of money!
Anyway, I'll try to resolved and figure out where is the static optic and OMC board and try to fix it...as soon as possible.
Merry Chrstmas and a Happy New Year!
InSoft Automation Unveils Imp Version 14
Revolutionizing Layout Planning and Automation InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes. Learn more……. |