Error at the end of the Exposure..???

[sistecopy]

Hi we have a problem with Metadimension 6.0.

After re install all the software on Power Edge 14200, because some virus cause damage to the hard disk array, I send jobs to the Prosetter 74 and I have this problem because only film 2 plates or I some cases 1 plate, and I need send again the rest of the separation plates.

Here is a image that the Metadimension reports.

http://www.softpressmx.com/Error.JPG

Also any knows the name of the program to see the process of the Prosetter and put news plates sizes and configure..? I think that called GUI or something like that..and where I can get it because the technical support says that give me the CD but I donnt have it...

Thanks

 

[AutomaticWork]

Are you using Speedway EM 6.1?

Are you using Speedway EM 6.1?

Use the Speedway EM from the Meta 6.0 DVD instead of the one from version 6.1.
You may have done an upgrade?!?

 

[sistecopy]

What do you mean..with EM..? to the driver or the SpeedWay Intallation Engine..

Thanks

 

[AutomaticWork]

Speedway Engine Manager

Speedway Engine Manager

Thats what I meant

 

[sistecopy]

Thanks a lot ...
I fix the problem...

Now you now where I can get the GUI software...When I buy the rip, I have it installed but I don't have the Setup or Cd installation..

thanks