Flat bed die cutter

[tpeetros]

I'm shopping for a small flat bed die cutter; one that doesn't require the use of matrix. I've been looking at the Trim & Perf 600 from SCS. Does anyone have any feedback of that machine or any suggestions for a different one?

thanks

 

[holyoni]

Hi there?
Did you have the opportunity to take a hand on Trim & Perf? I'm looking at this machine at the moment but didn't find any comments from users...

 

[Ynot_UK]

Hi there?
Did you have the opportunity to take a hand on Trim & Perf? I'm looking at this machine at the moment but didn't find any comments from users...

Welcome to the forum.
However the post you have replied to is over ten years old and the OP was last seen on the forum eight years ago...