GMCE Boot Stuck in Gboot mode

[rajmila]

Hi,

There is error while booting Trendsetter 800 IV. service shell error shows no communication with the BOOTP Server...... and I can see only Gboot mode only. I've checked Gmce network status -OK, Tried Host configuration -SUCCESS, try to load CR but fails to load GMCE Firmware. checked Power Supply voltage - OK.
Please check some snaps related to error.
It would be great if anybody help me in this issue.
Thanks,

 

[prepressrx]

Hi,

There is error while booting Trendsetter 800 IV. service shell error shows no communication with the BOOTP Server...... and I can see only Gboot mode only. I've checked Gmce network status -OK, Tried Host configuration -SUCCESS, try to load CR but fails to load GMCE Firmware. checked Power Supply voltage - OK.
Please check some snaps related to error.
It would be great if anybody help me in this issue.
Thanks,

Try replacing the RJ 45 communication cable.

 

[rajmila]

Try replacing the RJ 45 communication cable.

Replaced the RJ 45 cable but same error.

 

[rajmila]

Thank you for your kind reply.

 

[rajmila]

There was a change in firewall setting ie. turned on. after turned off it, the problem solved.

 

[prepressrx]

Funny,

There was a change in firewall setting ie. turned on. after turned off it, the problem solved.

Funny, I was just reading a bulletin about that a couple of days ago. So glad to hear you got solved.