Henry Pérez
Member
faint lines on the plate developer desoues
plates LOTEM 400
- Thread starter Henry Pérez
- Start date
PACH
Well-known member
Make sure that the chemistry is OK. very important.
Go over the calibration of the Lotem. Focus/ Intensity/ Resolution
Try a diferent batch of plate.
Good luck
Henry Pérez
Member
Thanks for the answer
Thanks for the answer
We review the focus and intensity and did a text with various intensities of 300 to 400 from 10 to 10 and speed resolution 100 600, 98% disappear in peak intensity of 400.
Damage that may result in the Lotem 400 or processes in addition to this I can do to make the laser not be forced to correct error in the plates eses initially palnteadi hairline lines across the plate.
I mean when I said to try a new production of the plate.
Thanks for the answer
We review the focus and intensity and did a text with various intensities of 300 to 400 from 10 to 10 and speed resolution 100 600, 98% disappear in peak intensity of 400.
Damage that may result in the Lotem 400 or processes in addition to this I can do to make the laser not be forced to correct error in the plates eses initially palnteadi hairline lines across the plate.
I mean when I said to try a new production of the plate.
Henry Pérez
Member
lines that appear throughout the motion are exactly continuous couples throughout the area from side to side
KevinC@EFI
Well-known member
Hi Henry - it's tough to diagnose this by email, especially with language challenges in between. Can I help you get in touch with a Kodak service channel? Where are you located?
Kevin.
Henry Pérez
Member
We would appreciate the contact with Kodak
We would appreciate the contact with Kodak
We are located in the city of Armenia Quindio - Colombia Phone 57 6 745 38 55 Henry Pérez
We would appreciate the contact with Kodak
We are located in the city of Armenia Quindio - Colombia Phone 57 6 745 38 55 Henry Pérez
KevinC@EFI
Well-known member
Hi Henry - I've asked my colleagues there to get someone in touch with you to help. Let me know if you don't hear from them.
Kevin.
Henry Pérez
Member
Hi Kevin, thanks for your timely help, but so far February 28 I have received no response to this request for help from contacts in this area for the solution of the problems I have with Lotem 400
KevinC@EFI
Well-known member
Sorry Henry - I've asked them again to get in contact with you, and will follow up tomorrow to ensure they have by then.
Kevin.
Similar threads
