Polar Mohr 66 Error 585

[Magnet23]

My Polar 66 cutter is giving a message Clamp Not in Upper Position - Acknowledge 585. So my automatic programming doesn't work, I have to manually input next cut. Any ideas?

 

[chock]

Hi sir;

Once a cut has been terminated and the knife returned to the upper dead centre a
timer is started (10 seconds) in the course of which the clamp has to recognize
switch B29.

If the return of the clamp is not registered during this waiting time the
above error message is issued.

Check mechanical adjustment of clamp guiding

- Check adjustment of recuperating spring

- Check adjustment of kinematics

- Check clamp travel time

- Check adjustment and functioning of S390 and S309 as well as switching cams

- Check clamp limit switch B29

- Check cabling to switches

Blessing
[email protected]
Mobile+WhatsApp:+505 8861 1441

 

[sidneykidney]

Maybe try turning the 'knife change' knob anti-clockwise (located under the table next to the on-off switch) and then turn it back to clockwise.

 

[chock]

Please follow the steps indicated before

• Yesterday at 6:53 AM
• Add bookmark
• #2

Hi sir;

Once a cut has been terminated and the knife returned to the upper dead centre a
timer is started (10 seconds) in the course of which the clamp has to recognize
switch B29.

If the return of the clamp is not registered during this waiting time the
above error message is issued.

Check mechanical adjustment of clamp guiding

- Check adjustment of recuperating spring

- Check adjustment of kinematics

- Check clamp travel time

- Check adjustment and functioning of S390 and S309 as well as switching cams

- Check clamp limit switch B29

- Check cabling to switches

Blessing
[email protected]
Mobile+WhatsApp:+505 8861 1441

 

[Magnet23]

Hi sir;

Once a cut has been terminated and the knife returned to the upper dead centre a
timer is started (10 seconds) in the course of which the clamp has to recognize
switch B29.

If the return of the clamp is not registered during this waiting time the
above error message is issued.

Check mechanical adjustment of clamp guiding

- Check adjustment of recuperating spring

- Check adjustment of kinematics

- Check clamp travel time

- Check adjustment and functioning of S390 and S309 as well as switching cams

- Check clamp limit switch B29

- Check cabling to switches

Blessing
[email protected]
Mobile+WhatsApp:+505 8861 1441

Unfortunately I don't know how to do any of this. I would need detailed instructions.

 

[chock]

Send me email

Blessing

[email protected]
Mobile WhatsApp:+5058861 1441