Problem with GTO 52-1 model 1997

[marantvou]

Hello my friends.
I have a problem with my GTO 52-1 model 1997. I turned on the main red switch this morning and then I pushed the start up button but the machine doesn't start up.
I noticed that also the step by step movement doesn't work. Do you have any idea what is happenig ? Thank you in advance.

 

[Manprint]

Did you check for any stop -especially close to blanket-, is there a green/red light on -if green light is on something else is afoot-

 

[marantvou]

Manprint, thank you for your help.
I found that the problem was a small ceramic 500 mA fuse on a pcb control board inside the box under the paper load. Thank you for your time.

 

[Manprint]

Good to see that your problem turned out minor, btw how much nip is needed to set your rollers -3mm oscillator and plate 3-3-2-2mm?-

 

[marantvou]

Hello Manprint.
What do you mean by the word "nip" ?

 

[Manprint]

The width of the roller on oscillation or plate τα πατηματα βρε αδερφε!

 

[Chris_PTA]

Ink strip width for all inking rollers should be 3-4mm

 

[aqazi81]

Good to see that your problem turned out minor, btw how much nip is needed to set your rollers -3mm oscillator and plate 3-3-2-2mm?-

For GTO it should be 4 mm to vibrator/oscillator roller and 3 mm to plate for 1st and 2nd form roller, 2mm for 3rd and 4th roller.
See the attached file, I hope this helps.

Regards

 

[Manprint]

Thank you for your input but thing is, the machine i work, is a DI -waterless- so nip pressure is a tad bit different than conventional