Prosetter 74. gives error 3260

[VitalyGroo]

Friends help! After moving Prosetter 74 gives error - (3260- An error occurred at material transport)
Looked all contacts and sensors. everything is clean. Advise where to look for the problem ...

 

[nineville]

material transport error

material transport error

Friends help! After moving Prosetter 74 gives error - (3260- An error occurred at material transport)
Looked all contacts and sensors. everything is clean. Advise where to look for the problem ...

3260 = Type ERROR
3260_UT = An error occurred at material transport.
3260_ST = Moving the flaps failed. They didn't reach their in-or-out target position.
3260_UH = Switch off the recorder and restart it. If the error still occurs, note down the error number and notify the service
department.
3260_SH = Check the unload flaps, sensors, power supply and cable connections on the backplane.


Just check the 2 light barriers for the moving of the flaps in and out if they are okay or
physically damaged. Check if the flaps are hanging on the feed table or if they ram into the gripper.

 

[simoesjo]

Hello,

you'll have to run the DIAG to discover this problem.

good luck.

 

[padrao]

Hello,

you'll have to run the DIAG to discover this problem.

good luck.

Gripper problems, you need a Heidelberg tech . . .