I'm not sure if this is the right section or where this problem is originating.
Having problems plating a single side of a form. The first side plated fine. The second side is another story. The job is submitted to the Trendsetter and the plate is loaded then the Trendsetter will just ilde and not load the plat onto the cylinder and just hang for minutes until the job is cancelled.
I'm not sure if this originating from the file that is going to be plated. There is a lot of transparency in it and I'm not sure if that is affecting it somehow.
Anyone have a similar issue? Any suggestions?
Having problems plating a single side of a form. The first side plated fine. The second side is another story. The job is submitted to the Trendsetter and the plate is loaded then the Trendsetter will just ilde and not load the plat onto the cylinder and just hang for minutes until the job is cancelled.
I'm not sure if this originating from the file that is going to be plated. There is a lot of transparency in it and I'm not sure if that is affecting it somehow.
Anyone have a similar issue? Any suggestions?