Hi there, good day to everyone. I am located in Trinidad and Tobago in the caribbean. We have a problem with our cutter and would like your assistance. I have always liked reading the forums and the way you guys corporate and help each other out in order to get back to work. I have a Polar Mohr 72ST and am getting no cut when cutting switches are pressed. We are getting the main motor running when switched on and the backgauge works fine as well as the cut line light works. Our electrician tested the cut switches and they all check out fine. We are getting no voltage at the clutch or safety bolt. Would anyone have a wiring diagram they would be willing to share so we can test the boards or any other recommendations you may offer? Many thanks in advance and have a blessed day.