Standard Finishing
4OverXerox

Announcement

Collapse
No announcement yet.

NX not imaging

Collapse
Canon
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • NX not imaging

    hi... my flexcell suddenly stopped imaging. can you help find solution? thnx

    "print consule does not support the following type of output device: GMCE Boot."

  • #2
    Hi, there's a problem with uploading firmware from PC to your setter, sometimes restarting CBootp service helps. There is an script in C:\creo\firmware : CBootp_Restart.Cmd , give it a try.

    Comment


    • #3
      thanks sir. i will give it a try... best

      Comment


      • #4
        taking the CTP out of boot state might need a Service Dongle to Connect to CTP Board, Also there is a Kodak Procedure to take GMCE board out of Boot state if Network Port is not Damaged on CTP Board Side

        Comment

        4OverCanonKBAAvantiXeroxSmartsoft (Presswise)Duplo

        Free Download

        Collapse

        Avanti
        Before You Buy A Print MIS Read This - FREE Download Link To Download

        4OverCanonKBAXeroxSmartsoft (Presswise)DuploAvantiXeikonGraph Expo

        What's Going On

        Collapse

        There are currently 2984 users online. 56 members and 2928 guests.

        Most users ever online was 6,611 at 11:23 AM on 02-27-2019.

        Working...
        X