Hello
Last month i'm trying to solve problem, so here is description. I got Agfa Avantra 25 with OLP and it was working perfectly until recently the equpment was moved to another building. There was a faulty power outlet, it had power on ground contact. The imagesetter was pluged in that outlet, and processor in normal outlet. When communication cable between imagestter and processor connected, the power installation fuse blown, and after checking outlets the fault was found, corrected, and now imagesetter works, but processor shows error message "Error nr 2004H".
I got service manual, it suggests that either temperature sensor is faulty or a/d converter has no power. Qualified electrician checked power supply on CPU board and all voltages are ok. Same message is displayed when all connectors to the processor control box are plugged out. The battery is also ok, it has 3V.
There is control unit inside processor "Glunz og Jensen", electronic type: 0506Y, date: 9724.
Three initial messages on processor power up are:
GI ATB V03 LUTH
GI 30A51 V01R04
120197 9707 0000
After those usual messages, message "Error nr 2004H" displays. When control panel on/off button is pressed, display shows "Motor off" and "Disconnect mains" messages mixed with "Error nr 2004H". Service codes work except for main motor, again mixed with "Error nr 2004H".
I read all other threads, but I didn't find any similar errors or solutions.
So if anyone have any ideas...
Last month i'm trying to solve problem, so here is description. I got Agfa Avantra 25 with OLP and it was working perfectly until recently the equpment was moved to another building. There was a faulty power outlet, it had power on ground contact. The imagesetter was pluged in that outlet, and processor in normal outlet. When communication cable between imagestter and processor connected, the power installation fuse blown, and after checking outlets the fault was found, corrected, and now imagesetter works, but processor shows error message "Error nr 2004H".
I got service manual, it suggests that either temperature sensor is faulty or a/d converter has no power. Qualified electrician checked power supply on CPU board and all voltages are ok. Same message is displayed when all connectors to the processor control box are plugged out. The battery is also ok, it has 3V.
There is control unit inside processor "Glunz og Jensen", electronic type: 0506Y, date: 9724.
Three initial messages on processor power up are:
GI ATB V03 LUTH
GI 30A51 V01R04
120197 9707 0000
After those usual messages, message "Error nr 2004H" displays. When control panel on/off button is pressed, display shows "Motor off" and "Disconnect mains" messages mixed with "Error nr 2004H". Service codes work except for main motor, again mixed with "Error nr 2004H".
I read all other threads, but I didn't find any similar errors or solutions.
So if anyone have any ideas...