Agfa Xcalibur 45S Vaccum Problem

[Selim Reza]

We'r using Agfa Xcalibur 45S CTP Machine. Recently at the time of Booting it is giving Massage "Vacuum low or missing" boot failed. Error No. J1341 Device - Job level automation.
We checked Compressor's air pressure it's ok. Chiller ok. Filters and others is ok. There is no air leak inside machine. Machine's rear panel meter showing air pressure 90 psi(as expected/required). Is air controller/sensor problems ?

So, if anybody help it will be highly appreciated.

Thanks
Selim Reza

 

[Armya Inc]

We'r using Agfa Xcalibur 45S CTP Machine. Recently at the time of Booting it is giving Massage "Vacuum low or missing" boot failed. Error No. J1341 Device - Job level automation.
We checked Compressor's air pressure it's ok. Chiller ok. Filters and others is ok. There is no air leak inside machine. Machine's rear panel meter showing air pressure 90 psi(as expected/required). Is air controller/sensor problems ?

So, if anybody help it will be highly appreciated.

Thanks
Selim Reza

and you will get a yellow sign on the screen and machine doesn't boot. You have problem with Pressure Sensor inside vacuum box. It doesn't sense the air pressure to order the Vacuum Pcb to activate the solenoids.
Did you have a problem with your compressor? Any water or oil inside the Compressor hose to the Machine?

Hope this will help!!

 

[Armya Inc]

and you will get a yellow sign on the screen and machine doesn't boot. You have problem with Pressure Sensor inside vacuum box. It doesn't sense the air pressure to order the Vacuum Pcb to activate the solenoids.
Did you have a problem with your compressor? Any water or oil inside the Compressor hose to the Machine?

Hope this will help!!

Reza,

My Pleasure! If you have any problem with aligning the sensor let me know.

Wish you the best!

[email protected]
1-416-706-5473