racincrazy
Member
I have a Avantra 30 that has been doing strange things. When I am able to image any film it will always cut a inch of the image off of the tail and it will appear on the next sheet every time. It constantly gives the 03 error code cutter jam. I have checked the cutter switch on the right side. The one that is the park or home position for the cutter. It also has a 197 FlapperB Motor ON Error During boot up but it will bypass it and finish booting up.
Things that have been changed after a big power surge are the DEC board, (it was toasted) The main board on the online processor, processor control panel board.
I was told by a guy that has a print shop up the street that they lost some electrical equipment at the same time my troubles started because of a large power surge.
Thanks Van
Things that have been changed after a big power surge are the DEC board, (it was toasted) The main board on the online processor, processor control panel board.
I was told by a guy that has a print shop up the street that they lost some electrical equipment at the same time my troubles started because of a large power surge.
Thanks Van