Hi..
I try to enter in Diagnose mode, because I have a trouble with the sensor table, when I send a Job from Metadimension to the Prosetter..the CTP think that have the plate, because starts to center and then mark error that there is not plate in the gripper.
But the Diagnose Software can not enter in diagnose I have some errors like:
1.- Target Prosetter not reachable or not in boot state.
2.- Command Reboot to DiagMode. Laste SpeedWay ERROR: 0. Power Down the recorder.
3.- or simple try to enter in diagmode and the program freeze.
All this i try to do it...when the CTP is online and donnt mark a error.
Any help...?????
Thanks..
I try to enter in Diagnose mode, because I have a trouble with the sensor table, when I send a Job from Metadimension to the Prosetter..the CTP think that have the plate, because starts to center and then mark error that there is not plate in the gripper.
But the Diagnose Software can not enter in diagnose I have some errors like:
1.- Target Prosetter not reachable or not in boot state.
2.- Command Reboot to DiagMode. Laste SpeedWay ERROR: 0. Power Down the recorder.
3.- or simple try to enter in diagmode and the program freeze.
All this i try to do it...when the CTP is online and donnt mark a error.
Any help...?????
Thanks..