DPX Platemaker Vacuum error

[Vernon@localgreenpress]

Hello to any DPX users
I've got an error on my rip - vacuum
I ran a plate and there wasn't any vacuum so plate was messy. I checked the fuse - No. 3 and it was ok.
Can anybody recommend anything before I call in the engineer?

Thanks in anticipation

Vernon

 

[aligh]

Hello to any DPX users
I've got an error on my rip - vacuum
I ran a plate and there wasn't any vacuum so plate was messy. I checked the fuse - No. 3 and it was ok.
Can anybody recommend anything before I call in the engineer?

Thanks in anticipation

Vernon

dear vernon
i repaired dotmate 7500 but 90 percent are same
as your mention no3 fuse ok. did you check voltage in vacuum unit?
we have vacuum fan that adjusted with vacuum motor(m9)
did you check and clean vacuumfan 's encoder and reflex sensor?
please check and clean it
waiting for your reply
regards