• Best Wishes to all for a Wonderful, Joyous & Beautiful Holiday Season, and a Joyful New Year!

Firmware OCP-module (Avantra44/Galileo VS) EEPROM

drinkings

Member
Hello all!

I'm actually searching for firmware OCP-module.
Not a flashrom! I need a part of firmware which I can burn to chip with programmer.

OCP-module doesn't answering to COM-port.

Sorry for bad arguements. I hope you'll understand my poor English.
 
Check your Skype, Sergei.
EEPRON contains:
Micro-controller
1. OCP User Parameters
2. Cassette Parameters
3. Operational Statistics
Read chapter 2 at Avantra Service Manual to understand the Functional Analysys
 
Volodya,
I know it, but my poor English not allow me explain my problem very well.
I think there are two parts of firmware that OCP-module contain...
One part is
Micro-controller
1. OCP User Parameters
2. Cassette Parameters
3. Operational Statistics
And second is like BIOS that operate all of them
Unidiag divides them as FLASHROM and FIRMWARE
In my case unidiag wrote that both had version like 0.00
I have nothing on OCP-module board.
I can't load FLASHROM cause my OCP-module's COM port doesn't work.
And I need the FIRMWARE to solve this.

...thank you and please translate this to good English for others...
 
Volodya,
I know it, but my poor English not allow me explain my problem very well.
I think there are two parts of firmware that OCP-module contain...
One part is
And second is like BIOS that operate all of them
Unidiag divides them as FLASHROM and FIRMWARE
In my case unidiag wrote that both had version like 0.00
I have nothing on OCP-module board.
I can't load FLASHROM cause my OCP-module's COM port doesn't work.
And I need the FIRMWARE to solve this.

...thank you and please translate this to good English for others...

Your English is O.K:). We all get it:D.
Have you ever downloaded the firmware ? It sometimes works and sometimes doesn't.
The best is to get a OCP pcb module and upload the firmware from this and download to the old one. In case if the old one after downloading the firmware fails, the new one can be replaced and you will have an operational firmware to download on other OCPs.
I have one for Galileo Vs and Agfa Avantra 44. It is fully functional.
Make me an offer, I will send it to you. Email me: [email protected]
 
Last edited:

InSoft Automation

InSoft Automation Unveils Imp Version 14

Revolutionizing Layout Planning and Automation

InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes.


Learn more…….

   
Back
Top