Fujifilm FLP-1260 Plate Processor Water Won't Turn Off Problem

KPS

Member
We have a Fujifilm FLP 1260 Plate Processor and when it does a replenishing cycle I notice the water isn't turning off where the spray bars are in the finishing station. Has anyone else had this problem and can tell me how to fix it? Thanks.
 

sveibl

Active member
Facing the plate delivery, open door/panel on lefthand side. there are solenoids that control water on/off in lower right.

We had them fail regularly and kept extras on hand.

I believe there are 2. If in doubt, swap connections and between the 2 to see if spray stops using other solenoid
 

KPS

Member
Facing the plate delivery, open door/panel on lefthand side. there are solenoids that control water on/off in lower right.

We had them fail regularly and kept extras on hand.

I believe there are 2. If in doubt, swap connections and between the 2 to see if spray stops using other solenoid
Thank You so much. I knew we had replaced one of the solenoids about a year or so ago and didn't even think to look at that.
 

Automatically Autonomous Automation

Automatically Autonomous Automation
Although the autonomous car is not quite ready, a lights out print operation is something you can do right now if you have a comprehensive Print MIS (Management Information System). The advantages can put money on your bottom line. So what’s your next step? Link to Article

   
Top