• Best Wishes to all for a Wonderful, Joyous & Beautiful Holiday Season, and a Joyful New Year!

Ink Temp. on HP Indigo 5000

H2Omark

New member
The press is reading zero temp. on Black, Mag. and Yellow. The Cyan says it is at 30.0 but I know that is not correct, because at start up it should be lower and then at get ready increase to 30.0. The conductivity are reading high. I have switched out the MIC board and checked fuses. Still same issue. I can of course bypass all the inks and print, but not knowing were the inks are at will not be a good thing. Any suggestions would be appreciate. We are not on a service contract, so I am winging on my own, and dead in the water.
 
Have you tried lowering the ink conductivity by removing some ink from the tanks and adding imaging oil? Have you checked the water flow from the cooler lines to the tanks?
 
Yes the water lines and chiller are fine. It is something to do with the press reading the correct info. on the inks. I have changed the MCN board and the DCH board and no change. Still down. Thanks the suggestion Milo....
 

InSoft Automation

InSoft Automation Unveils Imp Version 14

Revolutionizing Layout Planning and Automation

InSoft Automation announces the launch of Imp Version 14, the latest iteration of its industry-leading cost-based layout planning software. Packed with cutting-edge features, this release redefines efficiency, automation, and workflow optimization for printing and finishing processes.


Learn more…….

   
Back
Top