Hi
Can anyone advise wht are the preventive maintanence steps to be followed for ctp processor @ thermal plates?
1. How we will measure r identify the chemical strength ?
2. How much quantity replenisher need for a plate / level ??
3. Is it advisable to change the chemical every week r what is the frequency ??
4. As per the engineer instruction we never switched off our plate processor ? Is it right ??
5. For eg thro naked eye plates looks good but after printing fine lines r there over the job lightly , this happen becaz of week chemical. How to avoid/prevent such a type of error ??
6. How frequent we concentrate gum / gumming part on plate / processor ?
7. Is room temperature necessary to maintain the chemical strength ?
8. If auto replenisher wont work then how to manage it thro manually ?
regards
Kala
Can anyone advise wht are the preventive maintanence steps to be followed for ctp processor @ thermal plates?
1. How we will measure r identify the chemical strength ?
2. How much quantity replenisher need for a plate / level ??
3. Is it advisable to change the chemical every week r what is the frequency ??
4. As per the engineer instruction we never switched off our plate processor ? Is it right ??
5. For eg thro naked eye plates looks good but after printing fine lines r there over the job lightly , this happen becaz of week chemical. How to avoid/prevent such a type of error ??
6. How frequent we concentrate gum / gumming part on plate / processor ?
7. Is room temperature necessary to maintain the chemical strength ?
8. If auto replenisher wont work then how to manage it thro manually ?
regards
Kala