MadMike1
Member
hi everyone! i have an old mimaki jfx 1631 plus printer.
I want to create a new device profile. I have managed to do it in corolgate, but I can not set the waveform when printing. printing comes in stripes, not zigzag, because of this there are gaps between the stripes. if I use rasterlink and the profile downloaded from the official site, the wave is correct - zigzag, but the colors do not match at all.
Could you tell me where the waveform setting is located, this printer does not have this setting in colorgate. also this setting is not in mimaki profile master 2.
I want to create a new device profile. I have managed to do it in corolgate, but I can not set the waveform when printing. printing comes in stripes, not zigzag, because of this there are gaps between the stripes. if I use rasterlink and the profile downloaded from the official site, the wave is correct - zigzag, but the colors do not match at all.
Could you tell me where the waveform setting is located, this printer does not have this setting in colorgate. also this setting is not in mimaki profile master 2.
