Hi, I'm a newbie here to XMF. Hoping to pick someone's brains.
1 - Is there a way to run jobs in combo (several job numbers but stripped on same sheet)? I was told that they have to be under the same job number.
2 - Manual trapping, Can I manually trap to either over print or to KO?
3 - Trainer guy set up so my die lines are grayed out. They are fine for a pdf & epson proof, but will not be on the stripped up form.
Sometimes I need to export the die line stripped up. How can I change it?
Thank you!
1 - Is there a way to run jobs in combo (several job numbers but stripped on same sheet)? I was told that they have to be under the same job number.
2 - Manual trapping, Can I manually trap to either over print or to KO?
3 - Trainer guy set up so my die lines are grayed out. They are fine for a pdf & epson proof, but will not be on the stripped up form.
Sometimes I need to export the die line stripped up. How can I change it?
Thank you!
