New To XMF

[Topcat00]

Hi, I'm a newbie here to XMF. Hoping to pick someone's brains.
1 - Is there a way to run jobs in combo (several job numbers but stripped on same sheet)? I was told that they have to be under the same job number.
2 - Manual trapping, Can I manually trap to either over print or to KO?
3 - Trainer guy set up so my die lines are grayed out. They are fine for a pdf & epson proof, but will not be on the stripped up form.
Sometimes I need to export the die line stripped up. How can I change it?
Thank you!

 

[LFD_KN_Humongous]

Hello XMF users. I need to make a plate curve in XMF. Everybody (other 3 guys) quit in the prepress department and it's just me left. Help!!! Thanks!!!

 

[PeteKincaid]

Hi, I'm a newbie here to XMF. Hoping to pick someone's brains.
1 - Is there a way to run jobs in combo (several job numbers but stripped on same sheet)? I was told that they have to be under the same job number.
2 - Manual trapping, Can I manually trap to either over print or to KO?
3 - Trainer guy set up so my die lines are grayed out. They are fine for a pdf & epson proof, but will not be on the stripped up form.
Sometimes I need to export the die line stripped up. How can I change it?
Thank you!

Fuji resells our PACKZ PDF editor to XMF customers that need more editing capabilities and advanced trapping tools. You might want to check to see if that was part of your companies initial purchase. If not, you can reach out to your Fuji rep or hit me up on the side if you need more information.

Sorry I can't help you with your other question.