Old school

[kaiserwilhelm]

This could easily be in the wrong forum. If so, please move.
I have a Screen 4300 with TF V6. I go directly to the 4300 via PIF. I also own 1 bit tiff out option.
We acquired a new company with a Lotem 400. It is being driven by a Brisque.
I have searched in vain for a 1 bit tiff "raster blaster" that can drive this 2nd platemaker from my 1 bit tiff.
I have read of setting up the Brisque to take 1 bit tiff in and then process. To be honest, I have not touched a Brisque since 2002. I have lost a few brain cells since then .

 

[DavidMa]

We used a Brisque in front of our Lotem 800 up until a few months back when a power outage took it down for good.
I know it can be done, but, like you, it's been a while since it was set-up so I don't remember where we had it set at. I can't find out now that it is fried.

Maybe if you know a Kodak tech guy in your area, they can give you a hand.