avantra 25 agfa imagesetter BOOT problem

[Dieudos123]

Please I need help with avantra 25 imagesetter:
while booting it display error 220 first and then error155
therefore it dosn't finish to boot it stop at fifth line which is( DSP :45.09 )
it still display this line a long time.
five lines displayed in SYSTEM START-UP before it stop are:
First = DL: 1.5
Second = OCP: 45.15
Third = DIAG: 20.11
Fourth = CORR: 4.01-09
Fifth = DSP: 45.09
And what is the mining of these messages.Thanks in advance.

 

[VladCanada]

Versions of internal SW at DEC board and Operator Control Panel (OCP).

That means for me: you have Av25XT imagesetter, Revision 2.2 (the latest)

Error 220 - I have no info about that error number
Error 153 - Diag to OCP handshake failed.
Not shown DecK1: 45.17 line on the OCP

Fatal error!

As a user you unable to do anything to fix the problem, just reboot Avantra.
If errors appeared again - call for SERVICEMAN visit.

 

[jong mook kim]

That is DEC Board problem. I think you dont have AVDIAG program.
If you have, Run Monitor Mode-Restore Dec : XX.XX.hex file.-Rebooting-Same problem.

You Have to change DEC Board.

Thanks
Seouk Korea

 

[Dieudos123]

HI,
jong mook kim,thanks for your advice.
I have Avdiag but I don't have the transimission
cable between PC and Imasetter what kind of cable to use?
Thanks in advance.

 

[VladCanada]

Dieudos123, I really do not want to offend you personally,
but in case of DEC problem any unexperienced user with AvDiag becomes like
a monkey with a grenade in arms: one mistake and unpredictable grave consequences will come!!!

 

[jong mook kim]

Dear Dieudos123
you have avdiag proglem. Pls make a sub-dir (download).copy to download dir in 45.17 hex file.

Cable is special one for engineer.but We can make a ourself with Diagram.

Thanks

 

[pioneers]

Please I need help with avantra 30 imagesetter:
while booting it display six line at long time.
therefore it dosn't finish to boot it stop at six line which is DEC: 40.14
It still display this line a long time.
Six lines displayed in SYSTEM START-UP before it stop are:
First = DL: 1.5
Second = OCP: 30.15
Third = DIAG: 20.07
Fourth = CORR: 2.00-05
Fifth = DSP: 40.07
sixth = DEC: 40.14
And what is the mining of these messages.
tell me about the diagnostic Bridge Control Module through RS 232 serial cable.
Thanks in advance.
PIONEERS.