Al Ferrari
Well-known member
I am trying to recreate a cutter program that was inadvertently deleted and for which I have no back up, written or otherwise.
This program was used to press the air out of a lift of stock by starting the back gauge at the full depth of the lift, pressing it with the clamp at the set pressure, WITHOUT activating the knife, at a series of positions along the entire depth of the lift for the duration of the set clamp delay, advancing the back gauge to the next step and repeating the action until the full depth of the lift had been travelled. All of this in hands free automatic mode (hands off the buttons).
What I need help with is what is the function key needed at each step so that it is performed and the program advanced to the next step. I am sure this can be done since I've had the program for years until it got deleted. But since I have not needed to create one from scratch in a very long time, I have forgotten the function key and cannot seem to find it in the manual.
Can anyone please help.
Thanks,
Al Ferrari
This program was used to press the air out of a lift of stock by starting the back gauge at the full depth of the lift, pressing it with the clamp at the set pressure, WITHOUT activating the knife, at a series of positions along the entire depth of the lift for the duration of the set clamp delay, advancing the back gauge to the next step and repeating the action until the full depth of the lift had been travelled. All of this in hands free automatic mode (hands off the buttons).
What I need help with is what is the function key needed at each step so that it is performed and the program advanced to the next step. I am sure this can be done since I've had the program for years until it got deleted. But since I have not needed to create one from scratch in a very long time, I have forgotten the function key and cannot seem to find it in the manual.
Can anyone please help.
Thanks,
Al Ferrari
Last edited: