Screen 8000II error code

[Pressmanscooter]

Greetings all! I've been getting this error randomly. E4e01: Excessive current in the LD drive (driver 1 board).

Anyone have this issue? What was the cause/remedy? All help welcome!

Thanks
Scott

 

[chriscozi]

No affiliation just got good service - Platesetters

 

[pam_add]

Greetings all! I've been getting this error randomly. E4e01: Excessive current in the LD drive (driver 1 board).

Anyone have this issue? What was the cause/remedy? All help welcome!

Thanks
Scott

If error go off and return probleby bad laser if no bad laser drive board prepare power supply 5v 60 amp also in case

 

[voin]

There may be several reasons for this error...
Laser drive board #1, most likely faulty. To complete the diagnosis, you can swap boards (for example, #1 and #3 boards, AND ITS CURRENTS, please see att. photo). If after such swap, the CTP starts to show an error E4e03: Excessive current in the LD drive (driver 3 board). - then it's definitely a faulty board.

Hope this helps you diagnose!
Good luck!

 

[yachtsman]

ExChange Ld driver 1-3 first, if errod goes to anoder ld slot must rapair driver or buy new
If stay the same slot :
Check ld dioda, not all together, separately. If all steps not fix this up voltage 5v

my company rapair ld driver for 300euro.