avantra 30 error 33

[zouha2011]

i changed the film and press load but i have the error code 33 on the screen who could help me with it

 

[Candide17]

Hello from France!

Error 33 : No Media Currently Loaded
Go to the Pause Screen and load a media supply.

Perhaps a sensor problem...

You can download the Avantra manual here : http://www.google.fr/url?sa=t&rct=j...xCgv7Smq8sG10PR-w&sig2=GuoVWral-xREjo5VbTCe9Q

Fabrice.

 

[zouha2011]

to fabrice

to fabrice

Hello from France!

Error 33 : No Media Currently Loaded
Go to the Pause Screen and load a media supply.

Perhaps a sensor problem...

You can download the Avantra manual here : http://www.google.fr/url?sa=t&rct=j...xCgv7Smq8sG10PR-w&sig2=GuoVWral-xREjo5VbTCe9Q

Fabrice.

Merci , do you know the place of the sensor cause referred to the manual and still error 33

 

[zouha2011]

hello Fabrice
merci bien i referred to the manual but still the error do you know the place of this sensor?

 

[Candide17]

hello Fabrice
merci bien i referred to the manual but still the error do you know the place of this sensor?

Sorry, I'm a goldfish memory... I didn't use an Avantra since... 12 years!
But if you send me an email, I have the technical manual (pdf 4 Mo) of Avantra 36/44 and at page 2-30, you'll find what you're looking for (may be)...

Fabrice.

 

[zouha2011]

my email is [email protected] i will be grateful

 

[STSTech]

Zouha2011,

Before you start looking at sensor, as a problem. Make sure that the spindle is open on the one you are trying to load a new roll of film.


STSTech

 

[GeorgeHB]

It's been awhile since I've used an Avantra, but I recall getting an error message when loading film that was solved by removing the new film, and then reloading it into the film cartridge, then clearing the machine's error display, and then reloading. Of course, you'll have to be in the dark when you're doing the film part.

 

[zouha2011]

Thank you for your reply the media is loaded and bypassed the sensor then i have error 33 so i go back to pause screen and reload it i have got error 67 which means i have to cut media that's what i did then i have error 4 out of media and the roll still goes on without cutting till the processor and i force it to stop after an input jam error of the processor that why i thought of the sensor
thanks again hope find the problem

 

[Armya Inc]

Thank you for your reply the media is loaded and bypassed the sensor then i have error 33 so i go back to pause screen and reload it i have got error 67 which means i have to cut media that's what i did then i have error 4 out of media and the roll still goes on without cutting till the processor and i force it to stop after an input jam error of the processor that why i thought of the sensor
thanks again hope find the problem

I do not understand. Why did you bypass the sensor? Start all over again and try to explain in detail what you have done from start to end. Does your spindle A/B work?

 

[STSTech]

zouha2011,

Avantra is acting as if there is film blocking the film present sensor. Check the cutter assy for a short cut. A piece of film may be stuck in the cutter fingers blocking the sensor.


STSTech

 

[VladCanada]

99% you are right, STSTech!

 

[zouha2011]

thank you all STSTech you are right problem solved