We bought a Presstek Vector TX52 (used) in December 2010. We were able to make plates on the platemaker until about a week ago when we suddenly had a problem.
In the status box it says "OFFLINE". And it seems I can't get the the platemaker to connect to the rip computer again.
I have tried lots. (after making a disk image backup of the rip computer)
• Restarting and Restarting
• New USB cable
• Restoring the computer to a point when everything worked.
• Reinstalling the rip software. (Presstek Momentum)
• Installing the rip software to another computer.
Is there anyone that could help me with this? Thank you!
In the status box it says "OFFLINE". And it seems I can't get the the platemaker to connect to the rip computer again.
I have tried lots. (after making a disk image backup of the rip computer)
• Restarting and Restarting
• New USB cable
• Restoring the computer to a point when everything worked.
• Reinstalling the rip software. (Presstek Momentum)
• Installing the rip software to another computer.
Is there anyone that could help me with this? Thank you!