Manassasralph
Active member
Ok, for all you V180 owners.
I am printing a job, single sided, 20# cotton writing stock. Pulling from paper tray 1, stacking on top output tray.
If I finish FACE DOWN, I get a dog ear on the leading edge. If I finish FACE UP, no dog ear, runs perfect!
Any idea's? (Yes, I ran the job face up. But would like to know why there is a difference)
I am printing a job, single sided, 20# cotton writing stock. Pulling from paper tray 1, stacking on top output tray.
If I finish FACE DOWN, I get a dog ear on the leading edge. If I finish FACE UP, no dog ear, runs perfect!
Any idea's? (Yes, I ran the job face up. But would like to know why there is a difference)