Tony Blanco
Banned
Hello Print Planet people.
I am new here, and I would like you to help me with this issue.
I have an Avantra 44 which has some hard problems.
It cannot recognize the "A Flappers Sensors" and the "Carriage Home sensor" (both attached to the Take Up SDM)
The A flapper load sensor is always ON, and the A flapper image sensor is always OFF, even if you put a piece of plastic on it as actuator. Also the home carriage sensor is always ON (as it was disconnected)
I tried with two different DEC Boards and four different SDM Boards and the problem continues.
The original SDMs are 503 boards, I exchanged both between them, but the problem persists. Then I put two 501 SDMs but they present another problem (I think for incompatibility), for that, I took the chips of the 503 Boards and then I installed them onto the 501 Boards, but the problem persists.
Any idea????
Thanks in advance.
Tony Blanco
REPROCOLOR S.A.
Costa Rica, Centralamerica.
I am new here, and I would like you to help me with this issue.
I have an Avantra 44 which has some hard problems.
It cannot recognize the "A Flappers Sensors" and the "Carriage Home sensor" (both attached to the Take Up SDM)
The A flapper load sensor is always ON, and the A flapper image sensor is always OFF, even if you put a piece of plastic on it as actuator. Also the home carriage sensor is always ON (as it was disconnected)
I tried with two different DEC Boards and four different SDM Boards and the problem continues.
The original SDMs are 503 boards, I exchanged both between them, but the problem persists. Then I put two 501 SDMs but they present another problem (I think for incompatibility), for that, I took the chips of the 503 Boards and then I installed them onto the 501 Boards, but the problem persists.
Any idea????
Thanks in advance.
Tony Blanco
REPROCOLOR S.A.
Costa Rica, Centralamerica.
Last edited: