Lukas Engqvist
Well-known member
I'm trying to help out to set up some quality control procedures at my "old" job, so I'm wondering if there is any basic software to run reference check on a Ugra/Fogra Media Wedge CMYK v3.0.
The idea is that the operator should be able to scan his/her reference and see how values compare to standard, preferably using an iOne.
Also if there was a similar way that a TVI wedge could be compared to a normal/reference.
Basically needing a way to catch problems as early as possible. There are some full fledged systems that give full ISO compatibility read out… but they are too advanced… what's needed is something even a technophobe can use in a click-here, drag the meter along the strip and read the results. (as easy as taking temperature?)
Hope to match this to some kind of trouble shooting chart so that they can know which end to start looking to solve issues.
The idea is that the operator should be able to scan his/her reference and see how values compare to standard, preferably using an iOne.
Also if there was a similar way that a TVI wedge could be compared to a normal/reference.
Basically needing a way to catch problems as early as possible. There are some full fledged systems that give full ISO compatibility read out… but they are too advanced… what's needed is something even a technophobe can use in a click-here, drag the meter along the strip and read the results. (as easy as taking temperature?)
Hope to match this to some kind of trouble shooting chart so that they can know which end to start looking to solve issues.